chemical used for purification of water
Links
- 3, wear gloves, take about a bottle of disinfectant cap, pour into the basin, dilute with water according to the reference ratio. Dip a small brush into the diluted disinfectant solution and scrub the cage.
-
- 1, we should pay attention to the welding mesh moisture-proof: if it is just the general outdoor air humidity, do not bother. If the weather is foggy, use dry cotton cloth to wipe the bead on the welding mesh; If it rains, you should dry the water when the rain stops. Try to maintain and prolong the life of the welding mesh.
-
Post time: 24-08-22 -
-
In order to pack and bind galvanized wire in the surface of the sedimentary layer to local removal of surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank. Moderate rates of foam formation may be harmless. Small, homogeneous particles of large denier present in the bath can stabilize the foam layer. Use activated carbon mat to remove surface active substance. Or through filtration to make the foam is not too stable, which are effective measures; Other measures should also be taken to reduce the amount of surfactant introduced. The electroplating speed can be obviously reduced by the addition of organic matter. Although chemical formulations facilitate high deposition rates, the deposition of organic matter does not meet the requirements of coating thickness, so activated carbon can be used to treat the bath.
-
-
-
1. Used for mountain farming, road isolation, large farming enclosure protection, it is recommended that you choose 3mm wire diameter products.
-
Cold galvanizing (galvanizing) is in the plating tank after the current unidirectional, so that the zinc gradually plated on the metal surface, slow production speed, uniform coating, thin thickness, usually as long as 3-15g, bright appearance, poor corrosion resistance, usually a few months will rust. Compared with hot dip galvanizing, the production cost of electric galvanizing is lower.
-
Post time: 29-06-22 -
-
Post time: 06-09-22 - Galvanized wire to galvanized uniform, a body is now its cross section, the second is the longitudinal uniformity. In the actual operation process, such as the jitter of steel wire, the surface of the pot scum and other reasons will cause galvanized wire surface galvanized layer accumulation, should try to solve the problem.
-
Post time: 24-02-23 -
-
Post time: 18-04-23 -
2. Adjust the drawing process parameters of the water tank
-
Wire mesh is the iron screen with high corrosion resistance, the same is also one of the iron net class of widely used net class, its efficient corrosion resistance function in breeding industry, construction industry and other aspects are much liked. Its smooth and neat net surface, not only increased their aesthetic feeling, but also can play a certain decoration effect.
-
Post time: 17-03-23 -
Galvanized wire to galvanized uniform, a body is now its cross section, the second is the longitudinal uniformity. In the actual operation process, such as the jitter of steel wire, the surface of the pot scum and other reasons will cause galvanized wire surface galvanized layer accumulation, should try to solve the problem.
-
Hot dip galvanizing, also known as hot dip zinc, is the method of forming a layer of zinc coating on the surface of the workpiece after oil removal and rust removal, showing a clean and infiltrating surface, immediately immersed in the plating tank of zinc melting in advance. Cold galvanizing is the same after the removal of oil, in addition to lure, showing no pollution, infiltration of the workpiece hung into a special electroplating tank on the cathode, the anode with zinc. Switch on the DC power supply, zinc ions on the anode migrate to the cathode, and discharge on the cathode, so that the workpiece is coated with a layer of zinc layer hot dip galvanizing method.
- According to the different requirements of the industry, in the smelting furnace in accordance with the standard deployment, put the alloy ingot different weight, such as weave, Ming, paper, Lang, silicon, etc., the data out of the smelting is called gold ore. There are gray iron, white iron and the above-mentioned combined gold ore channels, each of which has its own distinctive characteristics, so they are used in industrial exploration and selection according to their own distinctive characteristics.
-
Post time: 14-12-22 -
During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
-
-
“In the booming pet industry chain, pet supplies market occupies a large share, which covers hundreds of categories such as toys, food, clothing and thousands of products.” An industry insider pointed out that the country’s pet supplies market is characterized by a wide variety of products, little competition and huge market potential.
- Nemator roller cage is connected by nemator connecting clasp with longitudinal tension bar fixed on the support, and the connection between longitudinal tension bar and support is selected. The 2.5mm cold-drawn galvanized steel wire is wound 2 times and then tightened and fixed. The bracket is set on the column and the cross side of the protective fence with a span of 3m. Other spans are only set on the upper part of the column, and the bracket and the protective fence are connected with the bracket hoop.
-
Stainless steel barbed rope in the way of corrosion is not very, because the surface is not treated but rely on its own raw materials for corrosion resistance, so there will be no chemical reaction. After a long time of use, it will not rust like the corrosion layer on the surface of hot dip galvanized barbed rope, because the internal material of stainless steel barbed rope is the same as the material on the surface. The most obvious difference in a short time is the cross section of this piece, hot dip galvanized barbed wire because of surface anticorrosion treatment, so there will be rust in the cross section of this piece, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
-
The physical methods mainly include manual rust removal and mechanical rust removal, chemical rust removal is generally the use of pickling method, practical application, usually according to the appearance of the workpiece rust status and different post-treatment process, choose different rust removal methods, among which pickling rust cleaning is more commonly used. That is, the iron and steel workpiece with oxide skin or rust is etched in the acid lotion, mainly to remove the oxide or rust layer on the surface of the steel.
-
The bonding and anchoring function between cold wire drawing and cold rolled ribbed steel bar and concrete is outstanding. Therefore, when used in components, the phenomenon of cracking of component anchorage area and damage caused by steel wire slip is fundamentally eliminated, and the load-bearing ability and anti-cracking ability of component end are improved. In reinforced concrete structure, the crack width is smaller than that of circular steel bar or even that of hot rolled thread bar.
- Bird food, now raising birds can be fed with bird food on the market, which is more convenient, of course, you can also feed some cereals, herbs and so on, in order to supplement nutrition.
- 185 compresores de aire diesel
- martelo de perfuração
- placa de triturador
- fábrica de martillo submarino a alta presión
- sand and gravel dredge pumps
- vertically suspended centrifugal pump
- la barra de perforación está hecha de los siguientes materiales
- ql80 hammer
- jaw crusher plate material
- panneau latéral de broyeur de titane