pqq coq10 with nac and glutathione
Links
Step-by-step plan for correct installation
If the seal is being fitted to original equipment you may have some influence over the shaft and housing bore finish, but if you are replacing a worn seal you still need to take into account the condition of these 2 essential parts. Check for sharp edges and burrs – particularly on the shaft and housing chamfers or you could ruin the seal before you start up. If the shaft is too worn consider using an M Barnwell Services Shaft Repair Kit.
⑤
Many – too numerous to list, covering a vast range of designs, sizes, and materials suitable for a never-ending range of applications. Some designs conform to International Standards such as BS1399 and DIN 3760 for metric sizes and seal types, but the majority have been manufactured to suit particular applications – hence the enormous selection available. This blog is intended to assist in this selection and will consider seal type, materials, and sizes.
Figure 2.10. Garter spring

Condition: New
Figure 14.3. Oil aging of fluoroelastomers.5 Chart shows percent retained elongation. Conditions: Aged at 150°C in Service Fluid 105 (oil changed every 168 h).
Corteco is a well-known brand in the automotive industry, supplying top-quality oil seals, including the first Simmerring® in 1929. The range consists of more than 7000 gaskets and more than 6500 OE-quality shaft and valve stem seals.
The most common oil seals are the ERIKS types R, RST, M and MST, which correspond respectively to types A, AS, B and BS according to DIN 3760/ISO 6194.
O.D. (outside diameter) surface The O.D. surface affixes the oil seal to the housing and prevents leakage , through the fitting area, of substances to be sealed, while excluding contaminants.