api pharma list
-
...
Links
-
- Barbed rope manufacturers specializing in galvanized barbed rope, hot dip galvanized barbed rope, blade barbed rope, stainless steel barbed rope, plastic coated barbed rope, positive and negative twisted barbed rope production for ten years.
-
Post time: 14-06-24 -
2. Adjust the drawing process parameters of the water tank
-
-
- The middle of the two thorns is 7 to 8 circles, while the ordinary thorn rope is only 3 and a half circles, showing neat and beautiful.
-
- The blade thorn rope is formed by the punching steel plate and mechanically rolled on the steel wire. The width of the blade is 22mm, the vertical distance between the two blades is 15mm, the longitudinal distance between the blade is 34mm, and the diameter of the core wire is 2.5mm. The blade is made of Q195 steel plate with 0.5mm thickness.
-
Post time: 24-02-23 -
Hot plating wire mixed rare earth and aluminum elements, make zinc liquid fluidity, more uniform coating, but also reduce zinc consumption. Hot-dip galvanized wire has better protective properties than cold galvanized wire, which makes it widely used in chemical experiment equipment. Hot plated wire coating is thick, so that it has good corrosion resistance, can be in the outdoor sun and rain and other harsh environment can be maintained for decades, so hot galvanized wire is widely used in construction, traffic guardrail and other outdoor facilities.
-
Post time: 13-09-22 - During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
-
-
Post time: 08-08-22 -
Steel mesh factory – improve the quality of reinforcement works. Electric welding wire mesh is produced by automatic intelligent production line under strict quality control in the factory. Strict control of mesh size, reinforcement specifications and quality. The omission of manual binding net is avoided, and the binding part is firm.
- Annealing is to restore the plasticity of wire, improve the tensile strength of wire, hardness, elastic limit, etc., the wire after annealing is called annealing wire. In the production process of annealing wire, it is very important to ensure the quality of the finished wire, make the wire have certain strength and suitable degree of soft and hard. The annealing temperature is between 800 ℃ and 850℃, and the length of furnace tube is lengthened appropriately for enough holding time.
- 2: plastic spraying blade barbed rope characteristics of beautiful color, according to the use of the environment to choose the color, so that it and the surrounding environment. Paint color including grass green, dark green, black, red, white and so on.
-
Post time: 10-04-23 - When in use, wrap into a roll cage. First, its ventilation is good, conducive to the air drying of corn; Second, occupy a small space, convenient drying, good air permeability, light transmission; Third, beautiful and strong, reusable, cost-effective. And in the storage process, it is easy to cover in rain and snow weather to avoid the deterioration of corn mold.
-
The use of electric welding mesh is very widely, but also used in different industries, different places, many times the name is named because of the use or use, so the use of electric welding mesh is doomed to a variety of different names. Can be called row welding mesh, or zinc plating welding mesh or galvanized welding mesh. There’s also the outer wall wire, which is just used for insulation, usually placed on the outside of the wall, to reduce heat emission.
-
Because the large volume of galvanized wire alloy elements in iron ore, can make the copper through the material thickening degree of strengthening, hardness, impact force, strength resistance, closing rate, elongation, so alloy iron in the exercise of good iron, is an important supplementary element. The difference between galvanized wire and general iron wire is very big, general iron wire is cheap, and because iron is not very stable, easy to rust in wet places, so the stability is not very good, life is not very long.
-
-
Post time: 18-10-22 -
Stainless steel barbed rope is often used in various engineering projects because of its good anticorrosion ability, but it is difficult to be accepted by ordinary families because of its high price. So what material of barbed rope has better anticorrosion ability?
-
Stainless steel blade barbed rope under normal circumstances, basically 20 or 30 years is no problem, but because of the problem of its own material will appear a certain degree of rust, this is also because usually stainless steel blade barbed rope used by the material is 304 material, in daily use if in a long-term humid environment will cause certain corrosion. But usually users buy stainless steel blade barbed rope is basically life will not have problems users can also rest assured to use.
-
In order to pack and bind galvanized wire in the surface of the sedimentary layer to local removal of surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank. Moderate rates of foam formation may be harmless. Small, homogeneous particles of large denier present in the bath can stabilize the foam layer. Use activated carbon mat to remove surface active substance. Or through filtration to make the foam is not too stable, which are effective measures; Other measures should also be taken to reduce the amount of surfactant introduced. The electroplating speed can be obviously reduced by the addition of organic matter. Although chemical formulations facilitate high deposition rates, the deposition of organic matter does not meet the requirements of coating thickness, so activated carbon can be used to treat the bath.
- The wide application of galvanized wire has brought great convenience to people’s production and life, but the production process of iron wire is also not to be underestimated. In industrial production, the production process of galvanized wire should be strictly controlled to ensure the quality of galvanized wire.
-
-
Barbed wire was used as a barrier to livestock theft, for one thing, because the surface was covered with sharp spikes that made it very difficult to penetrate through the barbed wire. On the other hand, it is because livestock generally have the habit of running into each other, which makes livestock dare not run into each other with the barbed rope, thus saving the user’s use cost.
-
Hexagonal barbed wire is divided into small hexagonal net and heavy hexagonal net. Heavy hexagonal net is also known as large hexagonal net, large size hexagonal net, mountain protective net, hanging net, stone mesh, gabion net.
- The screen is made into a box-like container, with stone filled with cages, can be used to protect and support seawall, hillside, road and bridge, reservoir and other civil engineering, flood control and flood resistance is a good material.
-
Galvanized wire in acid, alkali, sodium chloride aqueous solution of poor corrosion resistance, in the atmosphere containing carbon dioxide and hydrogen sulfide, as well as Marine atmosphere is not corrosion resistance. In high temperature and high humidity air and containing organic acid atmosphere is small, galvanized layer is also easy to be corroded. Galvanized wire and general wire is very different, general wire is cheap, and because the iron is not very stable, easy to rust in the wet place, so the stability is not very good, the life is not very long.
-
-
The use of electric welding mesh is very wide, can be used in many places. In the field of construction, especially the wall crack, has played a very important role, the traditional construction, is to put on mortar directly onto the wall, after such a long time, will appear fall off and fracture phenomenon, in order to prevent the occurrence of this phenomenon, must use welded wire mesh before rendering, welded wire mesh is fixed to the wall, above the plastering construction, Can ensure that the wall level for a long time, not easy to crack phenomenon.
-
Use in daily life does not need to carry out maintenance and maintenance, save a lot of time, but also save maintenance and maintenance costs. The annealed wire has good stability and corrosion resistance, which greatly prolongs its service life. There are many kinds, which can be selected according to different uses. The device for making anneal wire is simple, which improves the utilization rate of the device. The material properties of annealed wire can meet different processing requirements.
-
Post time: 29-12-22 -
Post time: 06-05-22 -
Welding net is made of high quality low carbon steel wire row welding, and then cold plating (electroplating), hot plating, PVC plastic and other surface passivation, plasticizing treatment, smooth surface, uniform mesh, welding spot firm, local machining good performance stability, corrosion resistance, corrosion resistance. Features: stainless steel welding net selection of high quality stainless steel wire row welding, more acid, alkali resistance, welding firm, beautiful, widely used characteristics.
- The common specifications of small hexagonal net in production are: the width is 1.22m, and the commonly used width is generally 1m. In terms of length, the small hexagonal net basically has no limitation. 1-100 meters can be produced. The production diameter of small hexagonal mesh is generally No. 27 wire to No. 18 wire, and the aperture size is 0.95cm-5.08cm.
-
- 185 compresores de aire diesel
- martelo de perfuração
- placa de triturador
- fábrica de martillo submarino a alta presión
- sand and gravel dredge pumps
- vertically suspended centrifugal pump
- la barra de perforación está hecha de los siguientes materiales
- ql80 hammer
- jaw crusher plate material
- panneau latéral de broyeur de titane
×